So to be safe, we recommend setting your humidistat’s relative humidity (RH) to 58 percent and setting your thermostat temperature between 77 and 80 degrees Fahrenheit. These settings will not maintain your selected temperature indoors but will maintain 58 percent humidity.

What is the best setting for a humidistat?

Set the humidity level on the humidistat to 58 percent. Although mold and mildew do not form at humidity levels below about 68 percent, Craig Muccio of the Florida Power & Light Company recommends a setting of 58 as humidistat gauges can be off by as much as 10 percent.

When should I turn on my humidistat?

If the temperature is near 0 F, set the humidistat to 25 percent. If the outdoor temperature is near 10 F, set the humidistat to 30 percent. If the outdoor temperature is near 20 F, set the humidistat to 35 percent. If the outdoor temperature is near 30 F, set the humidistat to 40 percent.

What should you set your humidistat at in the winter?

When setting the humidity in the winter, I always recommend to set the humidistat to the highest humidity level the home can support (up to 55%). Remember, higher humidity levels are healthier and lower utility bills because they are more comfortable.

How do you set up a humidistat?

Grab one humidistat lead and one black-colored low-voltage wire strand. Twist the ends together with pliers. Screw a wire nut over this pair of wires. The interchangeable humidistat leads, the two short pieces of wire extending from the rear of the humidistat, can connect to either black-colored low-voltage wire.

Does a humidistat save money?

By running your system to combat humidity, the humidistat can and will save you money on your electric bill. It will run your a/c system more efficiently sparing it the needless wear and tear and help extend the unit’s life.

What should humidistat be set at in Florida?

According to the EPA (Environmental Protection Agency), it is recommended that Florida residents keep the indoor relative humidity below 60% relative humidity. Ideally, that percentage should be between 30% to 50%.

What humidity grows mold?

Sometimes, humidity or dampness (water vapor) in the air can supply enough moisture for mold growth. Indoor relative humidity (RH) should be kept below 60 percent — ideally between 30 percent and 50 percent, if possible.

Is 65 humidity too high in a house?

The humidity level inside your house is just as important as the temperature. … The American Society of Heating, Refrigerating and Air-Conditioning Engineers (ASHRAE) recommends keeping the humidity below 65 percent, while the Environmental Protection Agency advises keeping it in a range between 30 and 60 percent.

Is a humidistat necessary?

It is not always easy to regulate the humidity level in your home, and that’s why you need a humidistat. It is a measurement device for monitoring and maintaining the humidity level in the air.

Article first time published on

How do you know if your humidistat is working?

Check the voltage on your humidistat control panel by turning your humidity settings very high or all the way up and use an ohm-meter to check the voltage. A voltage of zero means your humidistat is likely broken and it’s time to replace your control panel.

What is humidistat control?

A humidistat (sometimes called a humidistat control) is a device that works with a home’s heating and cooling system to automatically adjust the amount of moisture in the air to maintain a specific humidity level throughout the home.

Can a thermostat control humidity?

Your home’s thermostat is used to regulate the temperature, but it can also affect indoor humidity levels. In both the summer and winter months, humidity plays a role in your comfort and HVAC performance.

How do you set humidity control on Honeywell thermostat?

1. Rotate the adjustment knob clockwise on your Honeywell relative humidity control to turn it on. …
2. Set the relative humidity control according to the current outdoor temperature. …
3. Allow the system to operate for at least one full day before making any other adjustments.

What temperature should I keep my house in Florida?

The Centers for Disease Control actually recommends that an occupied indoor dwelling be between 75 degrees Fahrenheit and 80.5 in the spring and summer. Florida Power and Light says you need to keep the thermostat below 80 for at least part of the day just to keep your house from being overrun by mold.

What should I set my thermostat to in Florida?

Set Your Thermostat to 78 Degrees The Florida Public Service Commision also states that 78 degrees is the recommended thermostat setting in Florida.

How do you close up a Florida home for the summer?

1. Clean out your refrigerator.
2. Run water in all faucets for 10 minutes to flush system, then put olive oil (about one capful) in trap to seal in moisture.
3. Turn off the water.
4. Unplug the hot water heater/Turn off the breaker.
5. Make sure pool water supply autofill is still functioning.

Is 70 humidity in a house too high?

Research from the Building Science Corporation found that humidity of 70% or higher adjacent to a surface can cause serious damage to the property. The Health and Safety Executive recommends that relative humidity indoors should be maintained at 40-70%, while other experts recommend that the range should be 30-60%.

What is ideal humidity in a house in summer?

You may have thought, “What is the ideal humidity level for my house in the summer or winter months?” During the summer months, the average humidity should weigh in between 30-45 percent (below the 50% mark). Winter may require lower than 40% relative humidity to avoid condensation on your windows.

Does rain increase indoor humidity?

When it rains, it will increase the relative humidity because of the evaporation. The air where the rain is falling may not be completely saturated with water vapor. However, the longer it rains, the more the humidity will increase because of the air constantly drawing the water.

Will mold grow at 55 humidity?

A relative humidity greater than 55 percent is enough to support the growth of black mold. … Household problems such as water and pipe leaks cause water intrusion and an environment perfect for black mold to grow. The mold can continue to grow unabated if a small leak goes undetected for a long time.

Is 57 humidity too high?

Experts generally agree that the ideal indoor humidity levels for comfort and for avoiding health effects are between 35 and 60 percent. When you’re spending time in a home or workplace with humidity levels in excess of 60 percent, it’s increasingly likely that you will experience certain health issues.

Is 55 indoor humidity too high?

Too much humidity can cause mold, mildew and other contaminants to grow in your home. … During summer months, homes should have between 30 and 45 percent humidity. During the winter, humidity levels should be kept between 45 and 55 percent humidity.

Do Humidistats dehumidify?

Before the humidity ever reaches such an undesirable level, your humidistat would signal your dehumidifier to turn on. Once the desired humidity level is reached, the humidistat will turn off the dehumidifier.

Can a humidistat fail?

If there is a leak in the supply, or the connections have failed, the unit won’t work. The humidifier should be hooked up to the closest cold water line relative to the humidifier.

How do I test my humidistat dehumidifier?

You can test a dehumidifier humidistat fairly easily using a volt-ohm meter. Also using a volt-ohm meter, you can tell if the overflow switch works or not. Just set the meter to the RX1 scale and attach its leads to the humidistat’s terminals. Next check the humidistat with the meter.

How do you test aprilaire humidistat?

To check the humidifier operation, set the knob to “Test/Reset”, make sure that the water saddle valve is open and that there is electricity to the unit. The furnace blower motor must be operating and the furnace calling for heat for the Aprilaire Humidifier to function.

Does a humidistat measure relative humidity?

hygrometer to measure relative humidity, you will come across a humidistat hygrometer. … This is also commonly referred to as relative humidity in the atmosphere. If you want to record moisture levels in different locations, you will need a digital ThermoPro Hygrometer.